Bosch FWA 43 Series - TargetDataEditor; Remote ControlEx

1 690 326 006 2008-8-25| Robert Bosch GmbH
Operating System-Software | FWA 43xx / 44xx | 57 en
TargetDataEditor 14.11.7
TargetDataEditorFig. 35:
Function
Target-Data-Editor (TDE) is a separate program.
R
It allows editing and expansion of the user vehicle R
databank, to which the main program has access.
It does not start automatically with the remaining
R
modules but by opening the folder "FWA-CCD" on
the desktop user-interface or in the start menu
Programme>FWA-CCD.
Path/program files
C:\<program files>\FWA-CCD\WheelAligner\TDE
R
TDE_Spec3.exe R
Program start
manual
R
File description
TDE_Spec3.exe - executable program file
R
TDE.ini - Configuration settings of the TDE server. R
Further information are to be found in the Online i
Help TargetDataEditor.
RemoteControlEx14.11.8
RemoteControlExFig. 36:
Function
The software program "RemoteControlEx" must be
R
started before using remote control.
This helps to forward the command forwarded by
R
the Infrared receiver to the computer as well as to
the program (Wheel alignment system) that this can
be executed.
After starting the program, a symbol appears in the
R
taskbar.
The yellow symbol blinks while entering a function.
R
This takes place only if the command has not been
recognised by the software.
Task
With the help of the Irman 2 (Infrared receiver), the
R
computer can receive the sent infrared signal by the
remote control. The infrared receiver is attached to
the equipment cabinet and shall be connected via
a serial interface on the computer.
While entering the different functions with the
i
remote control, a prospect connection must be
present between the remote control and the infrared
receiver.
Path/program files
C:\<program files>\FWA-CCD\RemoteControlEx
R
RemoteControlEx.exe R
Program start
Auto Start-Group
R
File description
RemoteControlEx.exe - Executable program file
R
RemoteControlEx.ini - Configuration settings R
Further information are to be found in the Online i
Help FWA-CCD.