1 692 106 011 2019-03-26| Robert Bosch GmbH
Checking / calibration | HTD 6xx / HTD 8xx | 61 en
8. Switch on the beam setter and click on "OPTIONS".
9. Click on "SERVICE" in the "OPTIONS" screen.
SERVICE
10. Enter PIN: 835231
XXXXXX
11. Click on "PREVIEW" in the "SERVICE" screen.
Preview
i The laser cross must coincide with the vertical and
horizontal reference lines.
12. If this is not the case the camera must be adjusted.
To do this, loosen the display housing.
13. Adjust the position of the camera with an Allen key
until the laser cross coincides with the reference
lines.
14. Switch on the laser visor.
To Next Page
Loading...
