1 692 106 011 2019-03-26| Robert Bosch GmbH
78 | HTD 6xx / HTD 8xx | Mounting vertical alignment lasersen
3. Mount cover plate with holder for vertical alignment
laser.
1
2
3
4
Fig. 23: Mounting cover plate with holder
1 Fastening screws (4x)
2 Cover plate with holder for vertical laser
3 Adjusting screw alignment laser
4 Holder alignment laser
4. Remount holder for alignment laser and adjusting
screw alignment laser.
5. Snap the vertical laser into the holder (magnetic
bracket).
6. Secure the vertical laser with a securing cable.
1
4
2
3
Fig. 24: Assemble vertical laser
1 Locking pins
2 Retention magnet
3 Vertical laser unit
4 Safety cord
! It is essential that the vertical laser unit is located
properly on the locking pin and does not shift late-
rally anymore.
! Do not move the beam setter if the vertical laser is
not secured.
7. Calibrate the alignment laser and the vertical laser
(see „4.3 Zero point and laser visor – HTD 8xx“ and
„4.4 Vertical laser – HTD 8xx“).
To Next Page
Loading...
