MY21P01 - 22_1.0_24.09.2020
28
Overview
2. Battery level indicator
If the on-board computer is removed
from its mount, the last battery level
message is saved. The battery level
indicator can be read on the status
screen and in the status bar. You can also see the
battery charge level on the LEDs on the battery
itself.
A suitable message will be displayed if the battery
is being recharged on the pedelec. If the on-board
computer is removed from its mount, the last
battery level message is saved.
3. Riding light symbol
The riding light symbol is shown when the
riding light is on.
4. Level of assistance
The higher the level of assistance, the more the
drive system assists the rider when pedalling.
eMTB mode is available for Performance Line CX
drives. In eMTB mode, the assistance factor and
the torque are dynamically adjusted depending on
the pedalling force applied to the pedals. If the
pedelec has been configured with “eMTB mode”,
“eMTB mode” appears briefly when the SPORT
level of assistance is selected.
5. Clock indicator
The time is displayed in either 12-hour or 24-hour
format.
6. Power evaluation indicator
The power evaluation provides a graphic display
of the current speed (white bar) in relation to the
average speed. The graph allows the rider to see
directly whether the current speed is above or
below their average speed.
– Left of the black bar = below average speed
– Right of the black bar = above average speed
7. Own power
The power that the rider is currently applying to
the pedals is displayed as a bar.
8. Motor power
The motor power used is displayed as a bar. The
maximum motor power depends on the selected
level of assistance
9. Guidance bar
The guidance bar will tell the rider which screen
they are on. The screen that is open is highlighted.
10 Speed
The speed is displayed either in km/h or mph.
Colour of
screen
Explanation
White The battery charge level is over 30 %.
Yellow The battery charge level is between 15% and 30%.
Red The battery charge level is between 0% and 15%.
Red + ! The capacity for drive assistance has been used up.
The assistance is switched off. The remaining
capacity is reserved for lighting and the on-board
computer.
The battery capacity is sufficient for about 2 hours
more lighting.
Level of assistance Use
OFF When the drive system is switched on,
the motor assistance is switched off.
The pedelec can be used like a normal
bicycle by simply pedalling. The push
assist system cannot be activated.
ECO Limited assistance with maximum
efficiency for maximum range
TOUR Constant assistance, for long-range
tours
SPORT/
eMTB
SPORT Powerful assistance for sport rides on
mountainous routes and on urban roads
Table 22: Overview of levels of assistance
eMTB
available in
combination with
motors: BDU250P
CX, BDU365,
BDU450 CX and
BDU480 CX motors
Optimum assistance on any terrain,
sporty start-up, improved dynamics and
maximum performance
TUR BO Maximum assistance up to high
pedalling frequencies, for sport riding
Level of assistance Use
Table 22: Overview of levels of assistance
To Next Page
Loading...
