MY21P01 - 22_1.0_24.09.2020
70
Operation
6.13.2 Securing the on-board computer
It is possible to secure the on-board computer so
that it cannot be removed.
Figure 72: Position of headset screw
1 Undo headset screw (1) until the Kiox mount
can be swivelled sideways.
2 Insert on-board computer into the mount.
3 Fasten the blocking screw (M3, 6 mm long)
into its designated thread in the mount from
below. Never use a longer screw as this can
cause damage to the on-board computer.
4 Swivel mount back and fasten the headset
screw as per the manufacturer's instructions.
6.13.3 Removing the on-board computer
The on-board computer can be removed if it is
not secured.
Figure 73: Removing the on-board computer.
1 Grip the on-board computer by its top edge.
2 Pull on-board computer towards you until on-
board computer comes out of the magnetic
mount.
The system is switched off by removing the on-
board computer. Charging the on-board
computer battery
You can recharge the on-board computer battery
either on the pedelec or via the USB port.
6.13.3.1 Charging on the pedelec
The drive system will switch off automatically
after ten minutes if not activated if the pedelec
battery is not charging. The on-board computer
battery will also stop recharging in such a case.
The on-board computer will only charge when
switched on.
1 Switch on-board computer on.
2 Place on-board computer in its mount.
The charging process starts automatically.
6.13.3.2 Charging using the USB port
The on-board computer will only charge when
switched on.
1 Switch on-board computer on.
2 Open USB protective flap.
3 Connect a standard USB charger (not included
in the standard scope of delivery) to the USB
port on the on-board computer (5 V charge
voltage; max. 500 mA charging current) using
a micro USB cable or to the USB port on a
computer.
The charging process starts automatically.
If the on-board computer is switched off during
recharging, it cannot be switched on again until
the USB cable has been disconnected.
To Next Page
Loading...
