Bosch Kiox - Error Message; On-Board Computer

MY21P01 - 22_1.0_24.09.2020
50
Operation
6.3 Error message
6.3.1 On-board computer
The drive system monitors itself continuously and
displays a number as an error message if a known
error is detected. The system may switch off
automatically depending on the type of error.
Code Description Method of resolution
410 One or more on-board
computer buttons are
blocked
 Check whether buttons are
jammed because dirt has
accumulated between them,
for example.
 Clean buttons if necessary.
414 Control panel connection
problem
 Contact specialist dealer.
Have ports and connections
checked.
418 One or more buttons on
the control panel are
blocked.
 Check whether buttons are
jammed because dirt has
accumulated between them,
for example.
 Clean buttons if necessary.
419 Configuration error
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
422 Motor connection problem  Have ports and connections
checked.
423 Battery connection
problem
 Have ports and connections
checked.
424 Communication error with
components communi-
cating with one another
 Have ports and connections
checked.
426 Internal time-out error It is not possible to display or
adjust the tyre size in the basic
settings menu in this error status.
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
430 On-board computer
battery flat
 Recharge on-board
computer battery (while in its
mount or using USB port).
431 Software version error
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
440 Internal motor error
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
450 Internal software error
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
Table 33: List of on-board computer error messages
460 USB connection error 1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
490 Internal on-board
computer error
 Have on-board computer
checked.
500 Internal battery error
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
502 Fault in the lighting
1 Check the light and its
cabling.
2 Re-start the system.
3 Contact your specialist
dealer if the problem
persists.
503 Speed sensor error
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
504 Speed signal manipula-
tion detected
 Check position of spike
magnets and re-adjust if
necessary.
 Check for manipulation.
 Assistance from drive has
been reduced.
510 Internal sensor error
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
511 Battery internal error
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
530 Battery error
1 Switch off system.
2 Remove the battery.
3 Re-insert battery.
4 Re-start electric drive
system.
5 Contact your specialist
dealer if the problem
persists.
531 Configuration error
1 Re-start the system.
2 Contact your specialist
dealer if the problem
persists.
540 Temperature error
The pedelec is outside the
permitted temperature
range
1 Switch off the system to cool
the motor and battery down
or warm them to the
permitted temperature
range.
2 Re-start the system.
3 Contact your specialist
dealer if the problem
persists.
Code Description Method of resolution
Table 33: List of on-board computer error messages