MY21P01 - 22_1.0_24.09.2020
85
Cleaning and servicing
7.2.9 Cleaning the motor
Carefully clean the motor with a soft, damp
cloth.
7.2.10 Cleaning the brake
Clean brake and brake discs with a brush,
water and dish-washing detergent.
Clean brake discs thoroughly with brake
cleaner or spirit.
7.2.11 Cleaning the saddle
Clean the saddle with lukewarm water and a
cloth dampened with natural soap.
7.3 Servicing
7.3.1 Servicing the frame
Dry the frame.
Spray with care oil.
Clean off the care oil again after a short time.
7.3.2 Servicing the stem
Apply silicone or Teflon oil to the stem shaft
tube and the quick release lever pivot point.
If you have speedlifter Twist, also apply oil to
the unlocking bolt using the groove in the
speedlifter body.
Apply a little acid-free lubricant grease
between the stem quick release lever and the
sliding piece to reduce the quick release lever
operating force.
Burns from hot motor
The motor cooler can become extremely hot
during use. Touching it may cause burns.
Leave the motor to cool before cleaning.
Notice
If water penetrates the motor, it will be
permanently damaged.
Never immerse the motor in water.
Never clean with a pressure washer, water jet
or compressed air.
Never use cleaning agents.
Brake failure due to water penetration
The brake seals are unable to withstand high
pressures. Damaged brakes can fail and cause
an accident with injury.
Never clean the pedelec with a pressure
washer or compressed air.
Take great care when using a hosepipe. Never
point the water jet directly at the seal section.
Notice
Never clean with a pressure washer.
Never clean with solvent or chemical agents.
Required tools and cleaning agents:
• Cloths
• Toothbrushes
• Dish-washing liquid
• Care oil for frames
• Silicone or Teflon oil
• Acid-free lubricating grease
• Fork oil
• Chain oil
• Degreaser
• Spray oil
•Teflon spray
To Next Page
Loading...
