MY21P01 - 22_1.0_24.09.2020
84
Cleaning and servicing
7.2.5 Cleaning the chain
1 Slightly dampen a brush with dish-washing
liquid. Brush both sides of the chain.
2 Dampen a cloth with soapy water. Place the
cloth on the chain.
3 Hold and apply slight pressure while slowly
turning the rear wheel, so the chain passes
through the cloth.
4 If the chain is still dirty afterwards, clean with
lubricant.
5 Service the chain after cleaning.
7.2.6 Cleaning gear shift
Clean hub, gear shift and shift cables with a brush,
water and dish-washing detergent. Carefully clean
the twist grip with a damp, soft cloth.
7.2.7 Cleaning the battery
Clean the battery electrical connections with a
dry cloth or paintbrush only.
Wipe off the decorative sides with a damp
cloth.
7.2.8 Cleaning the on-board computer
Carefully clean the on-board computer with a
soft, damp cloth.
Notice
Never use aggressive (acid-based) cleaners,
rust removers or degreasers when cleaning
the chain.
Never use chain cleaning devices or chain
cleaning baths.
Notice
Never clean the hub, gear shift, shift cables or
twist grip with a pressure washer, steam jet or
aggressive cleaning agents.
Risk of fire and explosion due to penetration by
water
The battery is only protected from simple spray
water. Penetration by water can cause a short
circuit. The battery may self-ignite and explode.
Never clean the battery with a pressure
washer, water jet or compressed air.
Keep contacts dry and clean.
Never immerse the battery in water.
Never use cleaning agents.
Remove the battery from the pedelec before
cleaning.
Notice
Never clean the battery with solvents, such as
oil, thinners, alcohol or corrosion protection, or
with cleaning agents.
Notice
If water enters the on-board computer, it will be
permanently damaged.
Never immerse the on-board computer in
water.
Never clean with a pressure washer, water jet
or compressed air.
Never use cleaning agents.
Remove the on-board computer from the
pedelec before cleaning.
To Next Page
Loading...
