MY21P01 - 22_1.0_24.09.2020
71
Operation
6.13.3.3 Switching the on-board computer
on.
Figure 74: Position of On-Off button (on-board computer)
Press the On-Off button (on-board computer)
briefly.
The electric drive system is switched on.
6.13.4 Switching off the on-board
computer
If the on-board computer is not inserted into its
mount, it will switch off automatically after one
minute to save energy if no button is pressed.
Press the On-Off button (on-board computer)
briefly.
The electric drive system is switched off.
6.13.5 Lock (premium function)
The lock function can be purchased under the
<Shop> tab in the eBike Connect app. Once the
lock function is switched on, the e-bike drive unit
assistance is deactivated by disconnecting the on-
board computer. It can then only be activated
using the on-board computer belonging to the e-
bike.
You will find detailed instructions in the
online operating instructions at
www.Bosch-eBike.com/en/Kiox-manual
.
6.13.6 Using the USB port
The USB port can be used to operate external
devices which can be connected using a standard
micro A/micro B USB 2.0 cable.
The on-board computer and a sufficiently
charged battery must be in place on pedelec to
use the USB port.
1 Open protective flap on the USB port on the
on-board computer.
2 Connect the external device USB port with the
USB port on the on-board computer using a
micro A–micro B USB charging cable.
3 Replace the protective flap after using the USB
port.
6.13.6.1
Using the riding light
Figure 75: Position of riding light button
Notice
A USB connection is not a waterproof plug
connection. Any moisture penetrating through the
USB port may trigger a short circuit in the on-
board computer.
Never connect an external device when
cycling in the rain.
Always close the protective flap on the USB
port when cycling in the rain.
Regularly check the position of the rubber cover
on the USB port and adjust it as necessary.
Connected electrical loads may have an adverse
effect on the Pedelec range.
To Next Page
Loading...
