Bosch PROFESSIONAL GTS 10 - Technical Data; Noise;Vibration Information; Declaration of Conformity

English–71 619 P03 456 • (05.11) PS
Technical Data
Switchon actions cause brief drops in the mains volt
age. For unfavourable mains conditions, interference
with other equipment can occur.
For mains impedance of less than 0,181 Ω, no interfer
ence can be expected.
Noise/Vibration Information
Measured values are determined according to stand
ard EN 61 029 procedures.
The Aweighted noise levels of the tool are typically:
Sound pressure level: 90 dB(A)
Sound power level: 103 dB(A)
Measurement uncertainty K = 3 dB
Wear ear protection!
Declaration of conformity
We declare under our sole responsibility that this prod
uct is in conformity with the following standards or
standardization documents:
EN 61 029 according to the provisions of the direc
tives 89/336/EEC, 98/37/EC.
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Engineering Head of Product Certification
Robert Bosch GmbH, Power Tools Division
Table Saw GTS 10
PROFESSIONAL
Order number
3 601 L30 …
… 200
… 220
… 230
… 270
… 2E0 … 2G0 … 240 … 260 … 290
Rated input power [W] 1 800 1650 – 1 800 1 800 1 800
Voltage [V] 230 220 120 240 110 220/230
Frequency [Hz] 50 50/60 50/60 50 50 50/60
No load speed [min
1
] 3 800 3 800 3650 3 900 4 000 3 800
Weight
(according to EPTA Procedure
01/2003)
[kg] 27.2 27.2 27.2 27.2 27.2 27.2
Protection class / II / II / II / II / II / II
For maximum work piece dimensions,
see the "Working Instructions" Section
Dimensions of Suitable Saw Blades
Order number
3 601 L30 …
… 200
… 220
… 230
… 270
… 2E0 … 2G0 … 240 … 260 … 290
Saw blade diameter [mm] 254 254 254 254 254 254
Disk thickness of the saw blade [mm] 1.8  2.0 1.8  2.0 1.8  2.0 1.8  2.0 1.8  2.0 1.8  2.0
Teeth thickness/teeth setting, min. [mm] 2.8 2.8 2.8 2.8 2.8 2.8
Mounting hole diameter [mm] 30 30 16 25.4 30 25.4
GTS10_WEU.book Seite 7 Mittwoch, 2. November 2005 2:05 14