English–61 609 929 J73 • (06.03) PS
3 FUNCTION
While reading the operating instructions,
refer to the corresponding illustrations of
the power tool on the front pages.
Intended Use
The power tool is intended as a stationary machine for
making straight lengthways and crossways cuts in
wood.
Horizontal mitre angles of $60° to +60° as well as ver$
tical bevel angles of 90° to 45° are possible.
Product Elements
The numbering of the machine elements refers to the
illustrations of the power tool on the front pages of the
operating instructions.
1 Sliding table
2 Table extension
3 Table insert
4 Riving knife
5 Vacuum connection piece on the protective hood
6 Protective hood
7 Parallel fence
8 Sticker for marking the cutting line
9 Table width extension
10 Parallel fence of the table width extension 9
11 Saw table
12 Hand wheel for the raising and lowering of the saw
blade
13 Scale for the spacing of the saw blade to the par$
allel fence 7
14 EMERGENCY$OFF button
15 Front guide groove for the parallel fence
16 Angle guide for setting the horizontal mitre angle
17 Ring spanner (23 mm; 10 mm)
18 Holding screw of the saw blade storage
19 Mounting holes
20 Guide groove for the angle guide
21 Rear guide for the parallel fence
22 Pusher piece
23 Locking lever of the sliding table 1
24 Attachment screw for the parallel fence 10
25 Storage location for the auxiliary parallel fence 48
26 Storage location for the parallel fence 7
27 Locking knob for setting the vertical bevel angle
28 Safety flap for the on/off switch
29 Cable holder
30 Sawdust ejector
31 Storage location for the angle guide
32 Extraction hose
33 Bottom plate
34 "Riving knife" attachment set
35 Saw blade
36 Holder for the riving knife
37 "Protective cover" attachment set
38 Screws on the protective hood
39 Rubber bumper
40 "Table extension" attachment set
41 Clamping handle for the parallel fence
42 Cut$out for table insert
43 Spring clip
44 Adjustment screws for the table insert
45 Guide rail of the angle guide
46 Locking knob for the angle guide
47 Locking knob for the horizontal mitre angle
48 Auxiliary parallel fence (aluminium)
49 "Auxiliary parallel fence/angle guide" attachment
set
50 Profile rail
51 Attachment screw for the auxiliary parallel fence
52 "Table stand" attachment set *
53 Table stand *
54 Spindle lock
55 Clamping flange
56 Nut for saw blade attachment
57 Tool spindle
58 Angle indicator (horizontal)
59 Angle indicator (vertical)
60 Scale for the bevel angle (vertical)
61 Magnifier
62 Scale for the spacing of the saw blade to the par$
allel fence 10
63 On switch
64 Adjustment screw for adjusting the standard verti$
cal bevel angle of 90°
65 Adjustment screw for adjusting the standard verti$
cal bevel angle of 45°
66 Screw of the angle indicator (vertical)
67 Screw for parallel fence magnifier
68 Adjustment screw for sliding table 1 play
69 Handhold recess
* Not included with all machine versions
Not all the accessories illustrated or described are in>
cluded in standard delivery.
PTS10_WEU.book Seite 6 Donnerstag, 23. März 2006 11:47 11
To Next Page
Loading...
