English–71 609 929 J73 • (06.03) PS
Technical Data
Switch$on actions cause brief drops in the mains volt$
age. For unfavourable mains conditions, interference
with other equipment can occur.
For mains impedance of less than 0.181 Ω, no interfer$
ence can be expected.
Noise/Vibration Information
Measured values are determined according to stand$
ard EN 61 029 procedures.
The A$weighted noise levels of the tool are typically:
Sound pressure level: 97 dB(A)
Sound power level: 110 dB(A)
Measurement uncertainty K = 3 dB
Wear ear protection!
Declaration of conformity
We declare under our sole responsibility that this prod$
uct is in conformity with the following standards or
standardization documents:
EN 61 029 according to the provisions of the direc$
tives 89/336/EEC, 98/37/EC.
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Engineering Head of Product Certification
Robert Bosch GmbH, Power Tools Division
4 MOUNTING
Avoid unintentional starting of the power
tool. During mounting and for all work on
the power tool itself, the main plug must
not be connected to the power source.
Items Included
Also see the illustration of the delivered
items at the beginning of the operating
instructions.
Before putting the power tool into operation, check
that all of the items listed below have been delivered:
–Table saw
(premounted: table width extension 9, parallel
fence 10 and saw blade 35)
– Bottom plate 33
– 4 Philips head screws for mounting the bottom
plate
–Table extension 2
– "Table extension" attachment set 40
(2 guide rods, 2 screws for securing , 2 clips)
– Parallel fence 7
– Auxiliary parallel fence 48 with profile rail 50 and at$
tachment screws 51
–Angle guide 16
– "Auxiliary parallel fence/angle guide" attachment
set 49
(2 screws with square nuts and washers)
– Protective hood 6
– "Protective hood" attachment set 37
(screw, nut, washer)
– Riving knife 4
– "Riving knife" attachment set 34
(2 screws)
– Extraction hose 32
–Table insert 3
– Pusher piece 22
–Ring spanner 17
Table Saw PTS 10
Order number 3 603 L03 2..
Rated input power [W] 1 400
Voltage [V] 230
Frequency [Hz] 50
No load speed [min
$1
] 5 000
Weight
(according to EPTA Proce$
dure 01/2003)
[kg] 23.5
Protection class / II
For maximum work piece dimensions,
see the "Working Instructions" Section
Dimensions of Suitable Saw Blades
Saw blade diameter [mm] 254
Disk thickness of the saw
blade
[mm] 1.8
Mounting hole diameter [mm] 30
PTS10_WEU.book Seite 7 Donnerstag, 23. März 2006 11:47 11
To Next Page
Loading...
