Bosch rexroth 12 Series - Page 12

BoschRexrothAG, RE 92802-01-B/2023-03-27
12/60 A15VSO/A15VLO series 12 | Safety instructions
WARNING
Escaping hydraulic uid mist!
Risk of explosion and re hazard, health hazard, risk of environmental pollution!
▶ Depressurize the relevant machine/system component and repair the leak.
▶ Only perform welding work when the machine/system is depressurized.
▶ Keep open ames and ignition sources away from the axial piston unit.
▶ If axial piston units are located in the vicinity of ignition sources or powerful
thermal radiators, ashield must be erected to ensure any escaping hydraulicuid
cannot be ignited, and to protect hose lines from premature aging.
Escaping hydraulic uid due to leakage of machine/system components!
Risk of burning and risk of injury due to escaping hydraulic uid jet!
In case of leakage at the axial piston unit, high-pressure uid jets may escape.
▶ Depressurize the relevant machine/system component and repair the leak.
▶ Never attempt to block or seal the leak or hydraulic uid jet with acloth.
Hydraulic uid will explode when making contact with water!
Explosion and re hazard!
▶ Do not bring hot hydraulic uids in contact with water.
Electrical voltage!
Danger to life or risk of injury due to electric shock or property damage!
▶ Always disconnect the voltage supply to the relevant machine/system
part before installing the product and/or connecting or disconnecting the
connector. Protect the machine/system against being re-energized.
Danger from unexpected machine movement!
Danger to life or risk of injury! Unintentional or careless actuation of the manual
override of the solenoids can cause unexpected machine movements.
▶ Use the manual override only for functional testing or in the event of technical
malfunctions.
▶ Using the manual override on apermanent basis (e.g.by wedging, blocking)
isnot permitted.
▶ The use of the manual override is only permitted with limited technical data
(e.g.0.25 × maximum data).
▶ Check whether or not your machine requires additional safety measures for
your application to avoid unintentional actuation. If necessary, make sure these
are appropriately implemented.
▶ Wear suitable protective clothing.