Bosch rexroth 12 Series - Installation; Unpacking; Installation conditions

BoschRexrothAG, RE 92802-01-B/2023-03-27
26/60 A15VSO/A15VLO series 12 | Installation
7 Installation
Prior to installation, the following documents should be to hand:
• Data sheet of the axial piston unit (contains the permissible technical data,
main dimensions and circuit diagrams of standard versions)
• Installation drawing for the axial piston unit (can be obtained from your contact
person at BoschRexroth, if required)
• Hydraulic circuit diagram for the axial piston unit (in the data sheet and on the
installation drawing)
• Hydraulic circuit diagram for the machine/system (available from the machine/system
manufacturer upon request)
• Order conrmation (contains the order-related technical data for your
axial piston unit)
7�1 Unpacking
The axial piston unit comes in apolyethylene material (PE) corrosion protection
lm.
CAUTION! Danger due to falling parts!
If the packaging is not opened correctly, parts may fall out and damage the parts
or even result in injury.
▶ Place the packaging on alevel underground with sufcient load-bearing capacity.
▶ Only open the packaging from the top.
▶ Remove the packaging from the axial piston unit.
▶ Check the axial piston unit for transport damage and completeness;
see chapter 4 "Scope of delivery" on page 18�
▶ Dispose of the packaging in accordance with the regulations in your country.
7�2 Installation conditions
The installation position and location of the axial piston unit essentially determine
how it is installed and commissioned (such as when lling and air bleeding the
axial piston unit).
▶ Fasten the axial piston unit so that the expected forces and torque can be
transferred without any danger. The machine/system manufacturer is responsible
for sizing the fastening elements.
▶ Observe the permissible radial forces on the drive shaft when driving with radial
loading (belt drives). If necessary, store the belt pulley separately.
▶ Make sure the axial piston unit is always lled with hydraulic uid during
commissioning and operation. Also do this also after relatively long standstill
periods, since the axial piston unit may drain out through the hydraulic lines.
▶ Direct the leakage in the housing area to the reservoir through the highest drain
port. Use aline size that matches the port.