Bosch rexroth 12 Series - Commissioning; Initial commissioning

RE 92802-01-B/2023-03-27, BoschRexrothAG
Commissioning | A15VSO/A15VLO series 12 43/60
8 Commissioning
WARNING
Danger while working in the danger zone of amachine/system!
Danger to life, risk of injury or serious injury!
▶ Pay attention to and eliminate potential danger sources before commissioning
the axial piston unit.
▶ Make sure no one is in the danger zone of the machine/system.
▶ The emergency stop button for the machine/system should be within the
operator's reach.
▶ Always follow the instructions of the machine/system manufacturer during
commissioning.
CAUTION
Commissioning an incorrectly installed product!
Risk of injury and property damage!
▶ Make sure all electrical and hydraulic ports are connected or plugged.
▶ Commission only afully installed, fully functioning product with original
accessories from BoschRexroth.
8�1 Initial commissioning
During all commissioning work on the axial piston unit, observe the general
safety instructions and intended use detailed in chapter 2 "Safety instructions"
on page 8.
▶ Connect the pressure gauge for the working pressure, case pressure and suction
pressure to the specied measuring points on the axial piston unit or in the
hydraulic system, to check the technical data at rst operation.
▶ During commissioning, monitor the temperature of the hydraulic uid in the
reservoir to ensure that it lies within permissible viscosity limits.
8�1�1 Filling the axial piston unit
Professional lling and air bleeding is required to prevent damage to the
axial piston unit and to maintain proper function.
Usually, the cleanliness level of commercial hydraulic uids is insufcient for
the requirements of our components. These hydraulic uids must be ltered
during lling using an appropriate lter system to minimize solid particle
contamination and water in the system.
Use only ahydraulic uid that corresponds to the following requirements: