Bosch rexroth 12 Series - Performing flushing cycle

BoschRexrothAG, RE 92802-01-B/2023-03-27
42/60 A15VSO/A15VLO series 12 | Installation
On axial piston units with aHirschmann connector according to DINEN 175
301-803-A/ISO4400, the following tightening torques apply when mounting plug-in
connectors:
• Mounting bolt, M3(1): 0.5Nm
• Union nut M16 × 1.5 (2): 1.5–2.5Nm
1
2
Fig� 13: HIRSCHMANN connector
7�5 Performing ushing cycle
In order to remove foreign particles from the system, BoschRexroth recommends
aushing cycle for the hydraulic system before the rst commissioning. To avoid
internal contamination, do not include the axial piston unit in the ushing cycle.
Use an additional ushing unit to perform the ushing cycle. Follow the
instructions of the ushing unit's manufacturer for the exact procedure during
the ushing cycle.
Tightening torque for
Hirschmann connectors