Bosch rexroth 12 Series - Safety instructions; About this chapter; Intended use; Improper use

BoschRexrothAG, RE 92802-01-B/2023-03-27
8/60 A15VSO/A15VLO series 12 | Safety instructions
2 Safety instructions
2�1 About this chapter
The axial piston unit has been manufactured to generally accepted engineering
standards. There is still, however, arisk of personal injury or property damage if
this chapter and the safety instructions in this documentation are not observed.
▶ Read this documentation completely and thoroughly before working with the
axial piston unit.
▶ Keep this documentation in alocation where it is accessible to all users at all
times.
▶ Always include the required documentation when you pass the axial piston unit
on to third parties.
2�2 Intended use
Axial piston units are hydraulic components, meaning that in their application area
they are classied neither as complete nor as partly completed machinery in the
sense of the EC Machinery Directive 2006/42/EC. The component is exclusively
intended to form partly completed machinery or complete machinery together with
other components. The component should only be commissioned after it has been
installed in the machine/system for which it is intended, and the safety of the
entire system has been established in accordance with the Machinery Directive.
This product is intended for the following use:
The axial piston unit is only approved as apump for hydrostatic drives in an open
circuit�
▶ Observe the technical data, the application and operating conditions and
the performance limits as specied in the data sheet 92802 and in the order
conrmation. Information about approved hydraulic uids can be found in
datasheet 92802�
The axial piston unit is only intended for commercial use and not for private use.
Intended use includes having fully read and understood this documentation,
especially chapter 2 "Safety instructions" on page 8.
2�3 Improper use
Any use other than that described as intended use is considered improper.
BoschRexrothAG is not liable for damage resulting from improper use.
The user is solely responsible for any risks arising from improper use.
The following foreseeable forms of faulty usage are also considered improper
(this list is not exhaustive):
• Use outside the operating parameters approved in the data sheet and in the order
conrmation (unless specically approved by the customer)
• Use of non-approved uids, e.g.water or polyurethane components
• Changes to factory settings by unauthorized persons.