Bosch Rexroth IndraMotion MTX micro - Commissioning the drives

Fig.8-16: Configuring the signal trigger in the oscilloscope
Fig.8-17: Configuring the signal in the oscilloscope
After having completed the signal configuration, click on "Start". Then activate
the "Enable" checkbox in the "Drive-integrated Command Value Generator"
dialog (see window in Fig. 8-15). The axis is now moving with a defined velocity
and period, and all selected signals will be automatically measured by the os‐
cilloscope. See the figure below.
DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
Bosch Rexroth AG 101/141
Commissioning the Drives