Fig.9-2: VDP80 control panel – turning machine
The basic layout of the control panels is shown in the following figure. There
are 4 main groups (with red borders). Groups 1 to 3 are used to operate the
HMI software, and group 4 serves to execute the PLC functions of the machine.
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
110/141
Operating the IndraMotion MTX micro
To Next Page
Loading...
