Set up and connectNL
If you install the appliance as a standing
appliance, you must secure the
appliance against tipping over, e.g. by
screwing it to the wall or installing it
under a continuous worktop that is
firmly connected to the adjacent
cabinets.
1.Observe the safety instructions. →
Page 4
4.4 Drinking water connection
Connect the device to a drinking
water connection.
Install drinking water connection
Remark
¡If you replace the device,
you can use a new water supply
hose.
2.Observe the instructions for the
electrical connection.
1.The required steps can be found in
the supplied installation manual.
3.Check the contents of the packaging
and the condition of the device.
2.Connect the device to the drinking
water connection using the
enclosed parts.
4.The required installation dimensions can be
found in the installation manual.
5.Level the device using the
adjustable feet.
Observe the technical data.
3.Make sure that the drinking water
connection is not kinked, crushed
or tangled.
Make sure you have a firm stand.
6.Install the drain water connection.
→
Page 13
7.Install the drinking water
connection. →
Page 13
4.5 Electrical connection
Connect the device electrically
8.Connect the device to the
power.
Comments
¡Take the safety precautions
→
Page 4
into account.
¡Please note that it is
The security system only works
when the device is supplied with
power.
4.3 Drain water connection
Connect the appliance to a drain water
connection so that the contaminated
dishwashing water can be drained.
Install waste water connection
1.Connect the device plug of the
connecting cable to the device.
1.The required steps can be found in
the supplied installation manual.
2.Plug the power plug of the
device's power cord into a power
socket near the device.
2.Connect the drain hose to the
connection nipple of the siphon
using the supplied parts.
The connection details of the device
can be found on the rating plate.
3.Make sure that the drain hose is not
kinked, crushed or tangled.
3.Check the mains plug for tightness.
4.Make sure that the flow of water is
not prevented by a cap in the waste
water connection.
13