Final rinse system NL
use a degree of 21 °dH without
adding softening salt.
¡The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
Regenerating the water
softening system after x
washing cycles
6
Additional running time in
minutes
6
5
0.05
Additional water consumption in
liters
1.Press.
2.Approx. 3 seconds on
to open the basic settings.
Busy-
Additional consumption of electricity in
kWh
aThe display shows H:xx
to give.
aThe display shows
to give.
The stated consumption values are
laboratory measured values
determined in accordance with the
currently applicable standard and
using the Eco 50° program and the
factory-set water hardness value 13 -
16 °dH.
display
3.Repeatedly until the display
shows H:00.
press until
4.To save the settings, press for
approx. 3 seconds to press.
aThe water softening system has been
is switched on and the refill salt
indicator is deactivated.
11 Final rinse system
10.5 Regenerating the
softening system
11.1 Rinse aid
For optimal drying results, use the
best rinse aid.
Only use rinse aid for household
dishwashers.
To maintain trouble-free operation of
the water softening system, the device
regularly performs a regeneration of
the water softening system.
The water softening system is
regenerated in all programs before the
end of the main washing cycle. This
increases the running time and
consumption values of, for example,
water and electricity.
Fill rinse aid
If the rinse aid refill indicator lights up,
refill rinse aid. Only use rinse aid for
household dishwashers.
Overview of the
consumption values
when regenerating it
softening system
Here you will find an overview of the
maximum additional running time and
consumption values when regenerating the
water softening system.
29
To Next Page
