NLFinal rinse system
1.Press and lift the lip on the rinse aid
reservoir lid.
2.Approx. 3 seconds on
to open the basic settings.
Busy-
aThe display shows H:xx
to give.
aThe display shows
to give.
2
display
3.Just as often
until the display shows the
factory-set value r:05.
to press
4.Press or repeatedly until the desired
amount of rinse aid is set.
1
– At a low setting, less rinse aid is
added during the washing cycle,
which reduces streaks on the
dishes.
– At a higher setting, more rinse
aid is added during the washing
cycle, which reduces water
spots and improves drying
results.
2.Top up the rinse aid up to the max
mark.
max
5.To save the settings, press for
approx. 3 seconds to press.
3.If rinse aid has overflowed, it must
be removed from the rinse aid
container.
11.3 Switch off the rinse
system
Overflowed rinse aid can lead to
excessive foaming during the wash
cycle.
If the rinse aid refill indicator bothers
you, e.g. if you use a combined
detergent with a rinse aid component,
you can switch off the rinse aid system.
4.Close the lid of the rinse aid
reservoir.
aThe lid clicks into place audibly.
Tip:The function of the rinse aid is
limited in combined detergents. By
using rinse aid you usually achieve
better results.
11.2 Adjusting the amount of
rinse aid
If there are streaks or water spots on it
ven, please apply the
means.
crockery left behind
amount of gloss spray
1.Press.
1.Press.
2.Approx. 3 seconds on
to open the basic settings.
Busy-
30
To Next Page
Loading...
