214_58300000171747_ARA_EN_A – 01.03.a Seite 16 von 39
4.2 Iron components
1. Thermostat + thermofuse: The thermostat is the element
responsible for regulating the temperature of the soleplate
depending on the selection made by the user on the iron
temperature regulator. If the temperature of cutting at maximum
power (position "ooo" of the regulator) is 170 - 240°C in the
center of the soleplate is properly regulated. It is not factory
set.
In the same set, is included a safety bimetal, that acts as
thermofuse (temperature limiter) and interrupts the power supply
when the safety in the event of thermostat failure, temperature is
exceeded.
2. Steam intake: connection of steam hose from steam station.
3. Electricity supply: Phase and neutral
4. Electricity supply: Earth
To Next Page
Loading...
