214_58300000171747_ARA_EN_A – 01.03.a Seite 17 von 39
5 FUNCTIONS
5.1 Flowchart
The pump draws the water from the tank to the boiler. Priming the
pump valve returns water to the tank if the pressure is of-overreach
high.
The water is heated in the boiler until it is in steam phase and up to
the T connection.
If the boiler pressure is very high, the steam escaping through the
pressure to the tank valve.
Pressing the steam button, activates the solenoid valve, steam comes
out of the tank and goes to the steam regulator. The tank steam
induces a negative pressure in the boiler, which is balanced by the
entry of ventilation.
The amount of steam coming out of the iron can be adjusted by the
steam regulator knob (depend on the model).
To Next Page
Loading...
