214_58300000171747_ARA_EN_A – 01.03.a Seite 8 von 39
Never direct the steam jet at garments that are being
worn.
Never aim the steam at people or animals.
3.8 Cleaning & Maintenance
1. After ironing, pull out the plug and allow the appliance to cool down
before cleaning.
2. Wipe the housing, handle and iron body with a damp cotton cloth.
3. If the soleplate is soiled with dirt or scale, clean it with a damp
cotton cloth.
4. If the cloth is synthetic, it may melt due to the high temperature on
the soleplate . Switch off the steam and rub off any residue
immediately with a thickly folded, dry cotton cloth.
5. Never use abrasive products or solvents.
To keep the soleplate smooth, you should avoid hard contact with
metal objects. Never use a scouring pad, or chemicals to clean the
soleplate.
Important!
Always unplug the appliance from the mains supply
before carrying out any cleaning or maintenance
operation on it.
3.8.1 Cleaning the Boiler (calc’n clean)
To extend the life of your steam generator and to avoid any build up of
scale, it is essential that you rinse out the boiler after several hours of
use (approximately after 50 hours). If the water is hard, increase the
frequency.
Do not use descaling agents for rinsing out the boiler, as they could
damage it.
Depend on the model, pilot light (6) will flash indicating that boiler
must be rinsed.
1. Check that the appliance is cold and unplugged for more than
2 hours, and that the water tank (1) is empty.
2. Place your appliance on the edge of your kitchen sink.
3. Remove the plastic cover located on the bottom of the
appliance by turning it to the position.
4. Unscrew the boiler drainage plug using a coin.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
