214_58300000171747_ARA_EN_A – 01.03.a Seite 20 von 39
5.3 Auto shut-off (model dependent)
If during ironing, the steam release button on the iron handle is not
pressed for a certain length of time (8 minutes), the steam station will
automatically switch off.
In this case, the “auto shut-off” pilot lamp will flash:
To switch the steam station back on, press the steam release button
again.
Technically, this is done, including the Timer function in electronics,
which makes that after 8 min., disconnects the boiler and the
soleplate.
5.4 Energy saving (model dependent)
If the “Energy saving” button (8*) is switched on, you can save up to
25% of the energy and 40% of the water consumption (in comparison
to the maximum setting), and still achieve good results when ironing
most of your garments. It is advisable to use the normal energy setting
only for thick and very wrinkled fabrics.
Technically, the ECO function is to lower the temperature a few
degrees and therefore the pressure within the boiler. When the ECO
key is pressed, electronics cut before the boiler heating, but always
maintaining the temperature at levels sufficiently high to generate
steam.
The effect of this reduction in temperature is lower overall
consumption of the appliance:
• Set max. steam: aprox. 1,54 KWh
• Set max. steam + energy saving: 1,01 kWh
• Set min. steam + energy saving: 0,76 kWh
To Next Page
Loading...
