Bosch VCU - Page 63

Analog and Frequency Inputs | 11
Bosch Motorsport Vehicle_Control_Unit_VCU_Manual 63/136
Number of teeth on the
pulse wheel
Circumference of wheel
for speed calculation
Choose data type of the
measurement variable
Enter name to automatically
create a new measurement sheet
7. Click ‘Finish’ when done.
8. Enter the channel name and description.
9. Click ‘OK’ when done.
The channel is inserted into the Vehicle Control Unit VCU Project Tree.
Channel is linked
to REV01
Input pin
has hall
interface
Number of
teeth
Wheel
circumference
Available measurements for channel:
Measurement label Function
raw_name mV value of sensor
raw_name_fi filtered mV value of sensor
name physical value of sensor
name_fi filtered physical value
NOTICE
Measurement of ‘Revolution’ is similar.