Recording | 14
Bosch Motorsport Vehicle_Control_Unit_VCU_Manual 83/136
14.2.4 Displaying online recording diagnosis
("statectrl_ok")
1. To add a Recording Diagnosis element to a measurement sheet, drag a ‘Bit-LED’ ele-
ment from the Toolbox and drop it on measurement sheet.
2. Drag channel ‘statectrl_ok’ from the Data Area and drop it on the ‘Bit-LED’ element.
The ‘Bit-LED’ element shows the state of received channel data in bit-representation. A
green highlighted channel means 0, a red highlighted channel means 1.
– Measurement correctly initialized, but recording threshold(s) not reached: 254
– Measurement correctly initialized, Vehicle Control Unit VCU is recording data: 255
– Values less than 254 indicate an error state
14.3 USB recording
This function requires the installation of Software Upgrades. Look into the datasheet of
your device, to see which upgrades are available for your device.
Software Upgrade USB_DATA enables USB recording. To activate Software Upgrade
USB_DATA, enter the license key as described in the chapter ‘Feature activation’.
For USB recording, Software Upgrade FULL_LOG_1 should also be enabled.
Wiring harness
Bit Value
USB_Device_Power Power (red)
USB_Device_DP D+ (green)
USB_Device_DN D- (white)
USB_Device_Gnd GND (black)
For further information, see the pinlayout of the device.
To Next Page
Loading...
