26 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts AUTODOME IP starlight 7000 HD
2016-07 | 1.0 | F.01U.283.679 Operation Manual Bosch Security Systems
Power Supply Box Connections
The following figure is a detailed illustration of the Pendant Arm Power Supply Box, which
includes the fuse specifications.
P101
1 2 3
6 5 4 3 2 1 6 5 4 3 2 1
P106
XF102 XF103
XF101
(LED)
P107
5 4 3 2 1
GND TXD RXD C+ C-
P105
GND TXD RXD C+ C-
HTR DOME
a
Figure7.4: Pendant arm power supply box
1 Ground Screw 7 P101 Connector; Power In (120 VAC / 220
VAC)
2 From Harness (Nexus cable bundle) 8 P106 Connector; Control In/Out for external
audio input and output
3 In/Out; 1/2 in. (15 mm) NPS Fitting 9 P105 Connector; Audio to camera
4 Ethernet connector 10 Power In; 3/4 in. (20 mm) NPS Fitting
5 P107 Connector; 24 VAC to camera 11 Audio Input/Output; 3/4 in. (20 mm) NPS
Fitting (labeled “SERIAL COMMUNICATIONS”)
6 In/Out; 1/2 in. (15 mm) NPS Fitting
Warning!
In earlier Bosch AUTODOME cameras, cable 8 in the ARM mount is labeled “Control In/Out”
and was used for external RxD/TxD and Biphase communications. In the AUTODOME 7000
Series cameras: If you are mounting an AUTODOME 7000 Series camera to an ARM mount
that was wired for an earlier model of Bosch AUTODOME, you must either re-wire cable 8 to
be audio input and output, or disconnected it from the power supply.
Cables/wires that are routed through number 2 in the illustration above come from the Nexus
cable bundle that is in the pendant Arm.
To Next Page
Loading...
