Bose BUILT-INvisible TA-1

76
Appendix
Serial Commands to the TA-1 amplifier (continued)
Description Cmnd Arg Arg Values Action Notes/Examples
Ack enable
or disable
A p P = 0,1 Enables or
disables
Command
Acknowledgem
ents
A1<CR> =
Acknowledge enabled
A0<CR> =
Acknowledge disabled
Acknowledge = ‘>’ if
cmnd ok
Acknowledge = ‘?’ if
bad cmnd
Enable TA-1
responses
E nn nn = 00-FF Enables
selected DBIS
responses
Bit 0 = DIP switch
change detect
Bit 1 = 1 Enables TV
detection response
Bit 2 = 1 Enables IR
response
Bit 3 = 1 Enables LS
command response
Bit 4 = 1 Enables error
status response
Bit 5= 1 Enables DSP
PCB msg response
Bit 6 = 1 Enables DSP
PCB status response
Disable
TA-1
responses
D nn nn = 00-FF Disables
selected DBIS
response
Bit 0 = DIP switch
change detect
Bit 1 = 1 Disables TV
detection response
Bit 2 = 1 Disables IR
response
Bit 3 = 1 Disables LS
command response
Bit 4 = 1 Disables error
status response
Bit 5= 1 Disables DSP
PCB msg response
Bit 6 = 1 Disables DSP
PCB status response
Lifestyle

command
disable
L p P = 0,1 Disables Smart
Speaker
commands from
LS
L0<CR> = LS enabled
(default)
L1<CR> = LS disabled
Remote
input
disable
R p P = 0,1 Disables input
from IR remote
R0<CR> = Remote
enabled (default)
R1<CR> = Remote
disabled
TV sensor
ON or OFF
T p P = 0,1 Software TV
sensor
T1<CR> = simulates
TV sensor ON
T0<CR> = simulates
TV sensor OFF