Assembly / Owner’s Manual
42
TheConsoleSetupModeletsyouviewmaintenancestatistics(TotalRunHoursandSoftwareVersion)orfullyresettheConsole.
1. Push and hold down the Volume and PAUSE/STOP buttons for 3 seconds while in the Power-Up Mode to go into the Console Setup Mode.
Note:PushPAUSE/STOPtoexittheConsoleSetupModeandreturntothePower-UpModescreen.
2. The Console display shows the TOTAL HOURS the machine has operated.
3. PushtheENTER/STARTbuttonforthenextprompt.
4. The Console display shows the Firmware Version prompt.
5. PushtheENTER/STARTbuttonforthenextprompt.
6. TheConsoledisplayshowstheBLEVERSIONprompt.
7. PushtheENTER/STARTbuttonforthenextprompt.
8. The Console displays the DISCONNECT BLE prompt.
Note: If you want to disconnect the Bluetooth
®
transmitter, push the Increase/Decrease buttons to select the “DISCONNECT BLE YES”
option,andpushENTER/START.TheConsolewillexittheMachineSettingsModeandreturntothePower-UpModescreen.
9. PushtheENTER/STARTbuttonforthenextprompt.
10. The Console displays the UPGRADE BLE NO option. This option is for Service Technicians use only.
11. PushtheENTER/STARTbuttonforthenextprompt.
12. The Console displays the UPGRADE SOUND NO option. This option is for Service Technicians use only.
13. PushtheENTER/STARTbuttonforthenextprompt.
14. The Console displays the VIEW ERROR MSG NO option. This option is for Service Technicians use only.
15. PushtheENTER/STARTbuttonforthenextprompt.
16. TheConsoledisplaystheRESETCONSOLENOprompt.
Note: If you want to reset the Console to factory settings, push the Increase/Decrease buttons to select the “RESET CONSOLE YES”
option, and push ENTER/START. Turn the machine off when the Console displays the "POWER CYCLE NOW" prompt.
17. PushthePAUSE/STOPbuttontoexittheConsoleSetupMode.
The Console will display the Power-Up Mode screen.
Console Setup Mode