Note! The Current Values are saved in the battery-backup memory, and they will remain even if the
power is turned off.
RESET PRINTER
Resets the CPU unit and clears the buffer.
Must always be used if an error occurs (Printer Error in the display).
RESET ALARM
For alarms, the audio alarm can be reset (e.g. Printer Alarm, Out of Paper).
For errors (Printer Error in the display), however, the RESET PRINTER must be used.
Using the Menu Buttons
With help of the menu buttons (LAYOUT 1, LAYOUT 2, LAYOUT 3 and LAYOUT 4) the current
values can be changed.
The first push of a menu button shows which setting is currently active - its current value.
If these settings are correct, wait a few seconds for the timeout to expire, or press the RESET PRINTER
button and the setting will remain.
If you would like to change one of the settings, push the button several times, until the desired function
is shown on the display, then hold it down. By using SCROLL, the complete menu for the function can
be reviewed in the display. When the correct value is shown, release the button and either wait for the
timeout, or use RESET PRINTER.
The I/O and ASCII-table buttons differ slightly from this routine. Please see their button descriptions
previously in this chapter.
To Next Page
Loading...