Note! This command is to be used after all text in one volume has been transmitted to the Printer. If
text corresponding to less than two pages, or text with an odd number of pages is received, and not
followed by FF on the last page, the Printer will wait for more text or FF. This means that the last page
may be stuck in the Printer. This is due to the double-sided printing of the Printer. This command
makes the Printer to start printing the rest of the text. After this the paper position will be the same as
it had when this volume of text was started. Then page no. 1 on the next volume will start out
correctly. There will always be at least one blank sheet of paper between the volumes of text when
finishing each volume with a Software Form Feed.
Software Form Feed:
ESC 1 - Soft Form Feed
Software Form Feed
ASCII HEX
Software Form Feed 027 049 1B 31
2.8 Lines per Page, Example:
Lines per Page, Example.
Sheet Length,
Inches
Normal LineSpac
6 dot
Normal LineSpac
8 dot
Double LineSpac
6 dot
Double LineSpac
8 dot
4 9 7 6 5
5 11 9 7 6
6 14 11 9 8
7 16 13 11 9
8 19 15 12 11
9 21 17 14 12
10 24 19 16 13
11 26 21 17 15
12 29 23 19 16
13 31 25 21 18
14 34 27 22 19
To Next Page
Loading...