Note! The escape-sequences will be executed immediately if the printer is not running. However, if the
printer is running, the escape-sequences will keep their place in the document, and will be executed
when this particular page is printed.
Also keep in mind that any page formatting command must be kept on the front page of a sheet. Then
the command will affect both the front and back page, i.e. one sheet.
If there are page formatting commands on the back page of a sheet, these comands will be skipped.
Overview of the escape-sequences:
ESC A nn - Sheet length. nn can be from 08 to 28 (4 to14 inch).
ESC B nn - Line length. nn can be from 10 to 42 characters.
ESC C n - Print Format. n can be 0 or 1, single-sided (0) or interpoint (1).
ESC H n - Page Layout. n can be 0 or 1, Normal (0) or Z-fold printing (1).
ESC I n - Page 1 up/down. n can be 0 or 1, up (0) or down (1).
ESC J n - 6 / 8 dot braille. n can be 0 or 1, 6 (0) or 8 (1) dot braille.
ESC M nn - Line Spacing. nn can be from 0 to 16 step.
ESC N n - Line Single/Double. n can be 0 or 1, single (0) or double line spacing (1).
ESC R n - Page adjust. n can be from 0 to 9 lines.
ESC S n - Form Feed Mode. n can be 0 or 1, no form feed (0) or normal form feed (1).
ESC T nn - Page margin. nn can be from 0 to 20 step.
ESC 0 - Soft Reset
ESC 1 - Soft Form Feed
ESC 3 - ASCII-Table from PC
Please see the following explanations on how to combine different values to get the different escape-
sequences.
To Next Page
Loading...