Automation Guide Glossary V9.xx
100-214-273 Rev. 1 49
Switching preset memories
This is when different weld setups are stored in memory. They can be recalled from memory by the user
from the front panel, or remotely from the User I/O input pins if properly selected settings are chosen in the
System Configuration menu.
Sync in (see Sync out)
Sync out (Syncro weld cycle)
This is when multiple welders cycle against the same workpiece, and their ultrasonic power is started simul-
taneously in Sync for a particular application issue. Used in conjunction with Sync in.
(Another option would be to also release all the horns from the workpiece simultaneously. You can use a
longer than required hold time on each unit, then apply Cycle Abort to all the welders to make all retract
simultaneously.)
Warning
A user output signal that indicates a warning message was generated during the prior weld cycle. They are
of a class of minor operating conditions that do not generate a General Alarm output, but may be important
to the end-user (Energy Compensation occurred, for example).
To Next Page
Loading...
