Brasilia EXECUTIVE - Page 54

ENGLISH / 27
TROUBLE-
SHOOTING
CAUSES
SOLUTIONS FOR
THE TECHNICIAN
SOLUTIONS FOR
THE USER
Leakages occur
from the water
and steam pipes
with the relative
taps shut.
Sealing gasket defective or
presence of a foreign body
in the seal housing.
Check and replace if
necessary.
Contact authorized
service agent
Water or steam
leakages occur
under the tap
knobs during
opening.
Tap axis seals detective.
Check and replace if
necessary.
Contact authorized
service agent
A loss between
the group and
the filter holder
occurs during
delivery.
Underpan seal detective or
edge of fi lter irregular.
Replace.
Contact authorized
service agent
Loss of water
from the group
valves locking.
Seal detective. Replace.
Contact authorized
service agent
Loss of water
from the block
ring-nut during
manual loading.
Tap axis seal detective. Replace.
Contact authorized
service agent
Coffee goes out
from the sides of
fi lterholder.
• There are residues of dirt in
the seat of the fi lter holder,
which prevent the coffee from
passing through the nozzle.
• The seal of the group is
worn out.
• The funnels are clogged
• Clean
• Replace
• Clean or replace
The coffee is too
cold.
The machine is not ready. Wait until the temperature is reached, shown
by the warning light going out.
Coffee is not be-
ing dispensed or
it is being done
too slowly.
• Supply tap off.
• Water supply low.
• Dispensing hole of the fi lter
holder clogged.
•Turn on the tap.
• Check the supply line.
• Clean the fi lter holder well, using a special
detergent and a toothpick.