8
3. Flush Filters
New filters must be flushed before first use. First, remove filters from dispenser. Remove Side Filter Panel. One
at a time, rotate filter in a counterclockwise direction, then remove it.
A. Connect the filter to the Filter Housing
(D) by inserting the filter and rotating
clockwise until the BRIO logos on the filter
and the Filter Housing (D) are aligned.
D
B. Ensure both the cold water supply and
the shuto valve on the Shuto Valve
Tube (A) are in the OFF position. Connect
the elbow-connector end of the Shuto
Valve Tube (A) to the left side of the Filter
Housing (D).
C. Connect the Filter Flushing Tube (B) to the
right side of the Filter Housing (D) and lay
the open end of the Filter Flushing Tube
(B) over a sink or receptacle to collect
water. Turn on the cold water supply, then
turn on the shuto valve on the Shuto
Valve Tube (A).
B
D
A
To Next Page
Loading...
Need help?
General
