9
D. Flush the filter for a minimum of 5 minutes.
The recommended rate is 1.5-3 gallons of
water (about 10 minutes) or until the water
is clear in appearance.
E. Turn o the cold water supply, then turn o
the shuto valve on the Shuto Valve Tube
(A). Disconnect the tubing from the Filter
Housing (D) and repeat the process with
the remaining filter.
A
B
After filters are flushed, reinstall them in the dispenser by rotating clockwise.
4. Complete Installation
A. Remove blue silicone plug from Water Inlet (10).
B. Insert the elbow-connector end of the Shuto Valve Tube (A) into the Water Inlet (10). Secure with
Locking Clips (E) if desired.
E
C. Connect the power cord to a grounded GFCI outlet.
D. Turn on the valve on the Shuto Valve Tube, allowing water to enter the dispenser.