Model 621 User’s Manual INITIAL INSTRUMENT SETUP
Bristol Instruments, Inc. 9
Software Installation
The NuView Software provided on the Application Software CD controls the Laser
Wavelength Meter and displays the collected data. The CD also includes the Silicon Labs
USB drivers necessary to connect the PC to the Laser Wavelength Meter. The following
computer hardware is required to run the software.
A PC running Microsoft Windows 7 or Microsoft Windows 8
At least 1 GB of available RAM
USB 2.0 (or later)
Monitor
Mouse or other pointing device
1 Insert the Application Software CD into your CD-ROM drive. If Autorun is enabled on
your system, installation will start automatically. Otherwise, double click on the
installer to begin.
2 Once the software is installed, a shortcut to the NuView Software will automatically
be placed on the Start Menu (or Application Menu) of the PC. Click on this icon to
open the application.
3 Navigate to the “Help” menu and select “Manual” to open a PDF file of the 621 User’s
Manual (this file). This User’s Manual will describe installation and operation of the
621 system.
4 Open the Application Software CD folder. Click the folder labeled “SiLabs,” and then
the folder labled “CP210x_VCP_Windows.”
5 For a 32-bit operating system, double click on CP210xVCPInstaller_x86.exe; for a
64-bit operating system, double click on CP210xVCPInstaller_x64.exe. The
InstallShield Wizard will be activated, and follow the Wizard’s instructions until the
installation is complete.
To Next Page
Loading...
