Broadcom Brocade G620 - Attaching the Rear Brackets to the Rack Posts; Flush-Rear (Recessed) Mounting

53-1003990-22 Installation Guide Brocade
®
G620 Switch Hardware Installation Guide
Attaching the Rear Brackets to the Rack Posts
Perform the following steps to attach the rear brackets to the rack posts:
1. Attach the right rear bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts.
Use the upper and lower holes in the bracket.
2. Attach the left rear bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts.
Use the upper and lower holes in the bracket.
3. Tighten all 10-32 x 5/8-in. screws to a torque of 29 cm-kg (25 in.-lb).
Figure 10: Attaching the Rear Brackets to the Rack Posts
1. Screws, 10-32 x 5/8-in. Panhead Phillips
2. Retainer Nuts, 10-32
Flush-Rear (Recessed) Mounting
Flush-rear (recessed) mounting is similar to flush-front mounting except that the brackets are reversed on the device.
CAUTION
The device must be turned off and disconnected from the fabric during this procedure.
53-1003990-22
28