Broadcom Brocade G620 - FC Port (SFP+) Status LEDs

53-1003990-22 Installation Guide Brocade
®
G620 Switch Hardware Installation Guide
Table 12: System Status LED Patterns during Normal Operation
LED Color Hardware Status Recommended Action
No light The system is off, or there is no power. Verify that the system is on and has
completed booting.
Steady green The POST and initialization have
completed. The system is on and
functioning properly.
No action is required.
Steady amber (for more than 5 seconds
—can take over a minute to complete the
POST)
The system is going through the power-up
process.
No action is required.
Steady amber (for more than a few
minutes)
The system is in an unknown state, the
boot failed, or the system is faulty.
When the POST completes and the switch
has failed, a steady amber color may result.
Perform the following steps:
1. Connect a serial cable to the system.
2. Reboot the system.
3. Check the failure indicated on the
system console.
4. Contact your solution provider.
Flashing amber and green Attention is required. Several variables can
cause this status, including a single power
supply failure, a fan failure, or one or more
environmental ranges being exceeded.
Check the management interface and the
error log for details on the cause of the
status.
Contact your solution provider.
Management Port LEDs
Use the following table to interpret the management port LEDs.
Table 13: Management Port LED Patterns during Normal Operation
LED Function/State Hardware Status
Link/Speed—Green LED is on. 1000Mb/s link
Link/Speed—LED is off. 10/100Mb/s link
Activity—Green LED is blinking. Presence of activity
FC Port (SFP+) Status LEDs
Use the following table to interpret the FC port status LEDs.
Table 14: FC Port Status LED Patterns during Normal Operation
LED Color Hardware Status Recommended Action
The port has no incoming power, or there is
no light or signal carrier detected.
Verify that the power LED is on, and check
the transceiver and cable.
No light
The device may be currently initializing. Allow 60 seconds for initialization to
complete.
53-1003990-22
62