Broadcom Brocade G620 - Introduction; Supported Hardware and Software

53-1003990-22 Installation Guide Brocade
®
G620 Switch Hardware Installation Guide
Introduction
This guide contains installation procedures and safety requirements for installing your switch into a rack system or as a
stand-alone device.
Also provided are steps to initially configure the Brocade
®
G620 Switch for operation, to verify and monitor operation, to
replace switch field-replaceable units (FRUs), and to install transceivers and cables. Complete technical specifications for
the switch are also included.
Supported Hardware and Software
The Brocade G620 FC Switch is introduced in the Fabric OS
®
(FOS) 8.0.0 software release. The following tables list the
switch types, the power supply assemblies, the fan assemblies, and the rack mount kits supported on this device.
NOTE
•
Fabric OS 8.x refers to any supported release within the 8.x generation of Fabric OS.
•
Fabric OS 9.x refers to any supported release within the 9.x generation of Fabric OS.
Table 1: Brocade G620 and G620v2 Switches
Switch Type Description; Switch Type Introduced (OS) Currently Supported (OS)
162 G620 Fabric OS 8.0.0 Fabric OS 8.x, Fabric OS 9.x
183 G620v2 Fabric OS 9.0.0 Fabric OS 9.x
NOTE
To obtain the switch type, use the switchShow command.
Table 2: Power Supply and Fan Assemblies
Part Number Description Introduced (OS) Currently Supported (OS)
XBR-G250WPSAC-F 250W AC power supply with nonport-side
exhaust airflow
Fabric OS 8.0.0 Fabric OS 9.x
XBR-G250WPSAC-R 250W AC power supply with nonport-side
intake airflow
Fabric OS 8.0.0 Fabric OS 9.x
XBR-G250WPSDC-R 250W DC power supply with nonport-side
intake airflow
Fabric OS 9.0.1 Fabric OS 9.x
Table 3: Rack Mount Kits
Part Number Description
XBR-R000294 Universal two-post mid-mount or flush-mount rack kit
XBR-R000296 Universal four-post fixed rack mount kit
The following table differentiates between the Brocade G620 Switch operating under FOS 8.0.0 and 9.0.0.
53-1003990-22
6