Broadcom Brocade G620 - System Status LED

53-1003990-22 Installation Guide Brocade
®
G620 Switch Hardware Installation Guide
11. FC Port 62 (QSFP 3) Status LED
12. FC Port 63 (QSFP 3) Status LED
Figure 35: Brocade G620 Port-Side LEDs (Switch Type 183)
1. System Status LED
2. System Power LED
3. SFP+ (Upper) Port 0 Status LED
4. SFP+ (Lower) Port 4 Status LED
5. QSFP 0 (FC Ports 48 - 51) LED
6. QSFP 1 (FC Ports 52 - 55) LED
7. QSFP 2 (FC Ports 56 - 59) LED
8. QSFP 3 (FC Ports 60 - 63) LED
System Power LED
Use the following table to interpret the system power LED.
Table 11: System Power LED Patterns during Normal Operation
LED Color Hardware Status Recommended Action
No light The system is off, or there is an internal
power supply failure.
Verify that the system is powered on, that
the power cables are attached, and that
your power source is live.
If the system power LED is not green, the
unit may be faulty.
Contact your solution provider.
Steady green The system is on, and power supplies are
functioning properly.
No action is required.
System Status LED
Use the following table to interpret the system status LED.
53-1003990-22
61