53-1003990-22 Installation Guide
Brocade
®
G620 Switch Hardware Installation Guide
1. Retainer Nuts, 10-32
2. Rear Brackets (Right and Left)
3. Screws, 10-32 x 5/8-in. Panhead Phillips
Attaching the Rear Brackets to the Device
Perform the following steps to attach the rear brackets to the device:
1. Align the right rear bracket to the right rear of the device, and use four 8-32 x 5/16-in. panhead screws to attach the
bracket to the device. Be sure to insert the screws through the upper and lower slots in the bracket.
2. Align the left rear bracket to the left rear of the device, and use four 8-32 x 5/16-in. panhead screws to attach the
bracket to the device. Again, use the upper and lower slots in the bracket.
3. Tighten all 8-32 x 5/16-in. screws to a torque of 17 cm-kg (15 in.-lb).
Figure 25: Attaching the Rear Brackets to the Device
1. Screws, 8-32 x 5/16-in. Panhead Phillips
53-1003990-22
44
To Next Page
Loading...
