Broadcom Brocade G620 - Installing a QSFP Transceiver

53-1003990-22 Installation Guide Brocade
®
G620 Switch Hardware Installation Guide
Figure 30: Installing SFP+ Transceivers
1. Pull Tab of Transceiver in Upper Row
2. Pull Tab of Transceiver in Lower Row
4. Position a cable so that the key (the ridge on one side of the cable connector) is aligned with the slot in the transceiver.
Insert the cable into the transceiver until the latching mechanism clicks.
Figure 31: Installing SFP+ Cables
1. Cable and Connector
2. Transceiver
NOTE
Cables are keyed so that they can be inserted in only one way. If a cable does not slide in easily, ensure that
it is correctly oriented. Do not insert any unsupported cable that is intended for another type of transceiver
into a regular SFP+ transceiver. You may damage the cable as well as the transceiver.
Installing a QSFP Transceiver
Consider the following when installing these transceivers:
53-1003990-22
57