1-9
Electrical System:
Standard:
Electrical Group:
12V DC.
Battery:
Group 24 with 550 CCA rating.
Lighting Group:
Consists of 2 headlights and taillights, and a 12V horn activated by button on
instrument panel.
Display:
Located at operator's station and includes fuel gauge, voltmeter, oil pressure,
water temperature and hydraulic oil temperature gauges. Hour meter records
hours only during actual engine operation.
Outrigger Alarm System:
112-decibel alarm with alternating two-tone sound is actuated by a switch when
the OUTRIGGER DOWN controls are operated.
Back-up Alarm:
Provides pulsating 97-decibel sound from solid-state alarm when ignition is ON
and transmission is in REVERSE.
Optional Electrical Accessories:
Strobe Lights:
Two yellow strobe lights mounted on turret for high visibility. Flash 60-120
times per minute. Draw 0.5 amps each. Includes operator-controlled switch.
Boom Work Lights:
Two work lights, one on the side of the boom to light the boom tip, and one on
the side of the turret to light the ground under the boom tip. Includes switch at
operator's station. Net Weight: 10 pounds (5 kg)
Hydraulic System:
Standard:
Tandem pump mounted to rear end of hydrostatic piston pump, which is driven
by the engine crankshaft. Delivers 6 GPM (23 L/min) at 2600 PSI (179 bar) for
boom circuits and 17 GPM (64 L/min) at 2250 PSI (155 bar) for hoist circuit.
System protected by relief valves and two, 10-micron filters. Hydraulic
reservoir with a 14-gallon (53 L) capacity.
Boom Assembly:
Standard:
Three-section, high-strength steel construction, equipped with bearing pads for
efficient support and extension. Double-acting hydraulic cylinders extend
boom sections. The primary extension cylinder and the double-acting boom
elevation cylinder are equipped with direct connected holding valves. Boom
angle indicator provided on the side of boom.
To Next Page
Loading...
