1-4
SECTION 1
DESCRIPTION AND SPECIFICATIONS
BMC’s IC-40-2D is a self-propelled, industrial crane designed for in-plant lifting and material
handling applications. It has the special features of low height, narrow width, short length,
cargo deck, four-wheel steer, and four-wheel drive. The basic unit consists of a chassis
and a hydraulic boom assembly. The chassis includes a frame, four hydraulic outriggers,
an engine, a variable speed, hydrostatic transmission, and two drive axles with power
steering. The boom assembly includes a hydraulic-powered continuous rotation turret, a
three-section telescopic boom, a hydraulic boom-elevating cylinder, hydraulic boom
extension cylinders, and a hydraulic-powered hoist. A Rated Capacity Limiter is standard.
IC-40-2D:
This model includes a 3-section hydraulically extended boom with capacity of 9,000
pounds (4080 kg) at a 4-foot (1.2 m) load radius. It has a horizontal reach of 19.2
feet (5.8 m), and a vertical reach of 26.2 feet (8.0 m). Hoist is located on back of
turret.
GENERAL:
Length:
Chassis 10.7 feet (3.3 m)
Overall 12.2 feet (3.7 m)
Width: 64 inches (1.63 m)
Height:
Deck 31 inches (79 cm)
Overall 6.8 feet (2.0 m)
Wheelbase: 78.5 inches (1.99 m)
Ground Clearance:
Chassis 10 inches (25 cm)
Minimum (Axle) 8 inches (20 cm)
Angle of Approach: 24 °
Angle of Departure: 24°
Turning Radius: (Minimum) 9.8 feet (3.0 m)
Aisle Width: 90º Turn (Min.) 8.0 feet (2.4 m)
Travel Speed: (Max.) 10 MPH (16 km/h)
Outriggers:
Spread 7.7 feet (2.35 m)
Penetration 0.5 inches (12 mm)
To Next Page
Loading...
