8.2
8.28.2
8.2
Scrapers using
Scrapers usingScrapers using
Scrapers using
The cleaning of fire box allows guaranteeing that thermal efficiency is constant during long time. This type of
maintenance must be carried out at least once a day. To carry out it is enough to use the corresponding
scrapers, which are in the top part of the heater, realizing a lower movement up to down and vice versa
repeatedly.
8.3
8.38.3
8.3
Ash pan c
Ash pan cAsh pan c
Ash pan cleaning
leaningleaning
leaning
The ash pan must be emptied when it is necessary. The heater can’t be lightening without the ash pan inside.
8.4
8.48.4
8.4
Ash pan and
Ash pan and Ash pan and
Ash pan and burn pot
burn potburn pot
burn pot
door joints
door jointsdoor joints
door joints
The joints guarantee the airtightness of the heater and consequently the good functioning of the device.
It is necessary to control them periodically: if they are worn out or damaged they will have to be replaced
immediately.
These operations can only be carried out by an authorized technician.
For the correct functioning of the heater, an authorized technical service must proceed to its maintenance at
For the correct functioning of the heater, an authorized technical service must proceed to its maintenance at For the correct functioning of the heater, an authorized technical service must proceed to its maintenance at
For the correct functioning of the heater, an authorized technical service must proceed to its maintenance at
least once a year.
least once a year.least once a year.
least once a year.
If the power wire is damaged, it has to be replaced by service of technical assistance or, in any case, by a
qualified technician, avoiding useless risks.
8.5
8.58.5
8.5
Chimney cleaning
Chimney cleaningChimney cleaning
Chimney cleaning
During normal use, the device will not suffer any damage. When pellet is burnt slowly, tar and gasses are
emitted which (when combined with normal humidity) lead to creation of soot. An excessive build-up of soot
in the chimney can cause problems with the smoke discharge and a risk of fire.
Cleaning should be undertaken by a professional chimney-sweep and should be carried out when the device
is cold. It is advisable to check out the condition of the device at the same time and keep a note of dates on
which this work has been carried out
8.6
8.68.6
8.6
Glass c
Glass cGlass c
Glass cleaning
leaningleaning
leaning
IMPORTANT:
IMPORTANT:IMPORTANT:
IMPORTANT:
The glass must only be cleaned when it is complete
The glass must only be cleaned when it is completeThe glass must only be cleaned when it is complete
The glass must only be cleaned when it is completely cold to avoid the possibility of shattering .Commercial
ly cold to avoid the possibility of shattering .Commercial ly cold to avoid the possibility of shattering .Commercial
ly cold to avoid the possibility of shattering .Commercial
product may be used or alternatively clean it with moistened newspaper which has been dabbed in the
product may be used or alternatively clean it with moistened newspaper which has been dabbed in the product may be used or alternatively clean it with moistened newspaper which has been dabbed in the
product may be used or alternatively clean it with moistened newspaper which has been dabbed in the
ashes. Abrasive cleaners should not be used to remove deposits from the glass.
ashes. Abrasive cleaners should not be used to remove deposits from the glass.ashes. Abrasive cleaners should not be used to remove deposits from the glass.
ashes. Abrasive cleaners should not be used to remove deposits from the glass.
GLASS BREAKAGE
GLASS BREAKAGEGLASS BREAKAGE
GLASS BREAKAGE:
::
:
T
TT
The vitroceramic glass is resistant to temperatures up to 750 degrees and will not be
he vitroceramic glass is resistant to temperatures up to 750 degrees and will not be he vitroceramic glass is resistant to temperatures up to 750 degrees and will not be
he vitroceramic glass is resistant to temperatures up to 750 degrees and will not be
affected by rapid changes in temperature. It will only be damaged by mechanical shock, e.g. slamming the fire
affected by rapid changes in temperature. It will only be damaged by mechanical shock, e.g. slamming the fire affected by rapid changes in temperature. It will only be damaged by mechanical shock, e.g. slamming the fire
affected by rapid changes in temperature. It will only be damaged by mechanical shock, e.g. slamming the fire
door shut. For this reason, it is not included as a replaceme
door shut. For this reason, it is not included as a replacemedoor shut. For this reason, it is not included as a replaceme
door shut. For this reason, it is not included as a replacement part under the guarantee.
nt part under the guarantee.nt part under the guarantee.
nt part under the guarantee.
8.7
8.78.7
8.7
Exterior c
Exterior cExterior c
Exterior cleaning
leaningleaning
leaning
Do not clean the exterior of the stove with water or abrasive products as they could damage the surface. Use
a duster or a moist cloth.
..
.
8.8
8.88.8
8.8
Seasonal shutdowns
Seasonal shutdownsSeasonal shutdowns
Seasonal shutdowns
After cleaning the stove, the chimney and the flue pipe and completely removing any ash and residues, close
the doors and the air adjustments. The chimney must be cleaned at least once a year. Check the joints of the
device which, if damaged, will adversely affect its functioning and must be replaced. If the stove is installed in
a damp environment, put absorbent salts inside it. The interior cast iron will stay looking bright if it is wiped
with a little of vaseline.
At least once a year it is suitable to check and to clean the records of existing ashes in the low part of the
heater.
To Next Page
Loading...