7
a) Keep all heat sensitive or flammable materials at least 150 cm away from the device (furniture,
curtains, clothing, etc.)
b) When the device is going to be installed on flooring that is not completely insulated, a
fireproof base (such as a suitable constructional hearth and superimposed hearth) must be
installed.
c) Do not install the device close to flammable or heat-sensitive walls.
d) The heater must only be used with the ash pan in place.
e) We recommend the installation of a carbon monoxide detector in the room where the device
is fitted.
Ash must be collected in an airtight, fireproof container.
The fire must never be lit in the presence of gases or vapours such as linoleum glue, petrol, etc. Never leave
flammable objects near the fire.
WARNING! Both the firebox and t
WARNING! Both the firebox and tWARNING! Both the firebox and t
WARNING! Both the firebox and the glass become extremely hot and should never be touched directly.
he glass become extremely hot and should never be touched directly. he glass become extremely hot and should never be touched directly.
he glass become extremely hot and should never be touched directly.
If there is a fire either in the device or within the chimney then:
a) close the loading door.
b) close the air vents.
c) extinguish the fire using fire extinguishers of dioxide of carbon (CO2 powder).
d) call for the fire brigade immediately.
DO NOT TRY TO PUT THE FIRE OUT WITH WATER
DO NOT TRY TO PUT THE FIRE OUT WITH WATERDO NOT TRY TO PUT THE FIRE OUT WITH WATER
DO NOT TRY TO PUT THE FIRE OUT WITH WATER!!!
!!!!!!
!!!
5.2
5.25.2
5.2
Timber beams protection
Timber beams protectionTimber beams protection
Timber beams protection
Given the amount of heat produced by the device, special attention must be taken to protect nearby wooden
beams. When designing the fireplace both the proximity of the beams to the exterior surfaces on the fire, and
the heat emitted from the glass door need to be taken into account. The exterior faces of combustible beams
must not be subjected to temperatures exceeding 65ºC.
Some suggested solutions to this matter appear on the following drawing.
1-Beam;
2-Refractory Material Isolation;
3-Pothole;
4-Metallic protection;
PLEASE NOTE:
PLEASE NOTE:PLEASE NOTE:
PLEASE NOTE:
The manufacturer admits no liability whatsoever for any malfunction in any of its products if corre
The manufacturer admits no liability whatsoever for any malfunction in any of its products if correThe manufacturer admits no liability whatsoever for any malfunction in any of its products if corre
The manufacturer admits no liability whatsoever for any malfunction in any of its products if correct
ct ct
ct
installation procedures are not followed.
installation procedures are not followed.installation procedures are not followed.
installation procedures are not followed.
To Next Page
Loading...