Fig.24
To deactivate the alarm press the key nº
4
and the stove will come into the normally.
9.6.2
Electrical supply failure (Back out).
If a power outage takes place, when it is back again the stove will come into the
Final Cleaning
phase, until
the temperature of the stove reaches the accurate cooling temperature. Once this phase is finished, the stove
will remain shut down until the user starts it up again.
9.7
9.79.7
9.7
Alarm
AlarmAlarm
Alarms
ss
s
In case of any anomaly appears while operating, the electronic system of the stove will come in to show the
irregularities produced during the different operating modes, always depending on the type of anomaly.
Each alarm situation causes an automatic blockage on the stove. Pressing over the key nº 4 you will release
the stove. Once it reaches the accurate cooling temperature, the user will be able to start it up again.
9.7.1
Alarm smokes temperature probe
This alarm appears when the probe which detects the exit smoke temperature is broken or disconnected.
During this alarm phase, the stove will execute the shutting down procedure.
9.7.2
Alarm smoke excess temperature
It happens when the probe detects a smoke temperature over 250º C. Then on the display screen is shown
the following message.
Picture 25.
STARTING UP
FAILURE
FINAL
CLEANING
12:42
22 ºC P - 3
ALARM
PROBE
To Next Page
Loading...